User's Manual

Chapter 4: Configuring the Library
Configuring System Settings
96 Quantum Scalar i40 and Scalar i80 User’s Guide
Operator Panel
1 Select Setup > System Settings > Man Cart Assign.
2 Press Mo
dify.
3 Sc
roll to select Enabled or Disabled and press Apply.
4 Make anothe
r selection or press Exit.
5 Save
the library configuration (see Saving the Library Configuration
on page 101).
SNMP Enables or disables SNMP traffic to the library. This setting is enabled by
default.
Operator Panel
1 Select Setup > System Settings >SNMP.
2 Sele
ct the setting you want to modify and press Modify.
3 Sc
roll to select Enabled or Disabled and press Apply.
4 When
finished making all changes, press Exit.
5 Save
the library configuration (see Saving the Library Configuration
on page 101).
SMI-S Allows you to enable or disable SMI-S running on the library. This
setting is disabled by default.
Operator Panel
1 Select Setup > System Settings > SMI-S.
2 Press Mo
dify.
3 Sc
roll to select Enabled or Disabled and press Apply.
4 Make anothe
r selection or press Exit.
5 Save
the library configuration (see Saving the Library Configuration
on page 101).