User's Manual

Chapter 4: Configuring the Library
Working With Local User Accounts
Quantum Scalar i40 and Scalar i80 User’s Guide 85
12 Press the Up button to change the setting to Enabled.
13 Press Apply.
14 Cr
eate and validate the user password the same way you created
the admin password above.
15 Save
the library configuration (see Saving the Library Configuration
on page 101).
Disabling Passwords on
the Operator Panel
If you no longer want to use passwords on the operator panel, you can
disable them. Once you disable the Admin password, the user password
is also automatically disabled. You can only do this on the operator
panel.
Operator Panel
1 Select Setup > Account Settings > Password Settings.
Admin Password is h
ighlighted.
2 Press Mo
dify to modify the Admin password.
Enabled i
s now highlighted.
3 Press the Down button to change the set
ting to Disabled.
4 Press Apply.
5 Save
the library configuration (see Saving the Library Configuration
on page 101).
Modifying Passwords
on the Operator Panel
Once passwords are created, you can modify them.
Operator Panel
1 Select Setup > Account Settings > Modify Password.
2 Use the Up and Down buttons t
o select admin or user.
3 Press Apply.
4 E
nter the current password and press Apply.
5 Enter
a new password and press Apply.