User's Manual

Chapter 4: Configuring the Library
Working With Local User Accounts
84 Quantum Scalar i40 and Scalar i80 User’s Guide
You can enable just the admin password (and NOT the user password).
However, you can not enable just the user password.
Operator Panel
You start out by creating the admin account password. Once created,
you are logged out and need to log back in using the admin password.
Then you can create the User account password.
1 Selec
t Setup > Account Settings > Password Settings.
Admin Password is h
ighlighted.
2 Press Mo
dify.
Disabled
is now highlighted.
3 Press the Up button to change the setting
to Enabled.
4 Press Apply.
5 Y
ou are prompted to create the password. The password is a 4-digit
code (no letters or other characters). The first digit of the code is
highlighted. Use the Up and Down buttons to select a number for
the first digit, then press Right to go to the second digit. As you
move off the digit you created, it displays as a # symbol so that only
the digit you are working on displays actual numbers. If you need to
view or change a digit, press the Left button.
6 When
you are finished creating the admin password, press Right
until the Validate Password prompt appears. Re-enter the
password the same way you created it. When finished, press Apply.
A confirmation screen displays.
7 Press OK.
The library logs the session out and th
e operator panel displays the
login screen, with the User ID of admin highlighted.
8 Press Apply to go to the password line.
9 Usi
ng the directional buttons, enter the admin password you
created and press Apply.
10 Selec
t Setup > Account Settings > Password Settings.
11 Press the Down button to highlight User P
assword and press
Modify.
Disabled is
highlighted.