User`s guide

Chapter 6 Maintaining Your Library
Maintenance Actions
Scalar i6000 User’s Guide 432
Partial System Tests 6
The partial system tests perform the selected subtests to test an area or
range of the library configuration. The selectable tests include:
• Frame test - This test includes the same individual tests as the
installation verification test, but enables you to specify a range of
modules rather than testing all modules.
• Configuration test - This test includes the picker assembly and
scanner fiducial tests.
Both tests enable you to select a range of modules and racks to test. For
example, if you have a four-module library, you can select to test only
modules 3 and 4. The frame test performs the same operations as the
installation verification test, except there are frame and rack range
parameters available.
FRU Operational Tests 6
The FRU operational tests enable you to verify the replacement of a FRU.
When the FRU test is selected, you can select any of the following
individual tests:
• Accessor assembly
• Picker assembly
• Drive sled assembly
• I/E station assembly
• Scan barcode
When one of the subtests is selected, you may be prompted to enter
additional information. For example, the Select FRU dialog box has tabs
along the top to select individual drives, I/E stations, and scratch tapes.
Custom Library Alignment Tests 6
The custom tests enable you to run a sub-test that is normally part of the
larger tests that call multiple sub-tests (such as Installation, Partial, etc.).
Please refer to the Verification Test Functions section for more specific
information about each sub-test.