User`s guide

Chapter 6 Maintaining Your Library
Maintenance Actions
Scalar i6000 User’s Guide 411
4 Select Calibrate.
5 Click St
art.
During the calibration teach process, the picker moves to the home
position,
which is X-Y coordinate position 0,0. Then, for each rack of
each module, the picker moves to a magazine at the top and one at
the bottom and stores those positions in coordinates relative to the 0,0
position. Teach results appear in the Results area when the process
completes. If the calibration teach process completes successfully, the
Teach dialog box could close automatically.
Saving and Restoring
Library Configuration 6
The library’s save and restore capabilities enable you to save a remote or
local copy of configuration settings for the library’s drives, I/O blades,
and partitions, including the allocation of drives, storage magazines, and
I/E station magazines to each partition. If the library’s current
configuration becomes lost or unstable, you can use the LMC to apply the
locally or remotely saved configuration image, which eliminates the need
to reconfigure the entire library to bring it back to its original state.
The Save and Resto
re Library Configuration dialog box enables you to:
• Save a library’s configuration settings as a
remotely or locally stored
image
• Restore, revert, or rescue the library by applying a remotely or locally
store
d image of a library’s configuration settings
As a result of restore, rescue, or revert operations,
the library shuts down. You must have physical
access to the library to bring the library back up.
If you are performing a restore, rescue, or revert
operation using remote access, the library will
remain shut down until the library is directly
powered back on.
Note
Use the Physical Library command on the Setup
menu to disable or enable automatic inventory
after a calibration teach. For more information
about this command, seeSetting Up Policies for the
Physical Library on page 159.
CAUTION