User`s guide

Chapter 6 Maintaining Your Library
Maintenance Actions
Scalar i6000 User’s Guide 369
The Details button displays the Drive Details dialog box. For more
information, see
Viewing Drive Details on page 369.
4 In the Drive(s) area, click the appropriate drive row to highlight it.
5 Perform operations in either the Fibre Channel Parameters area or
the Control area of the Drives dialog box.
Viewing Drive Details 6
1 On the Drives dialog box in the Drive(s) area, click the appropriate
drive row to highlight it.
2 Click Details.
Identify button Causes status LEDs on the back of the specified drive to blink rapidly so that
you can identify it. When you click Identify, a message appears that informs
you that you can now identify the drive by the rapidly blinking LED on the
back of it. After you find the drive, click OK to stop the rapid blinking.
Self Test button For LTO-type drives only, runs a pass/fail test on the specified drive. This
button is available only when you select an LTO-type drive.
Eject button Ejects any currently loaded tape from the specified drive.
Get Drive Log
button
Enables you to mail or save the log of a Fibre drive that is attached to an I/O
blade (see Mailing, Saving, and Printing Test Logs
on page 467). This button is
available only for I/O blade-attached Fibre drives that are properly connected
and configured. If the button is not available for a Fibre drive, verify that it is
properly connected to the I/O blade and that communication is established
between them.
Clean Enables the drive cleaning process (see Cleaning a Drive
on page 374).
Element Description