User`s guide

Chapter 4 Configuring Your Library
Using LDAP
Scalar i6000 User’s Guide 231
2 In the General tab, you can enable or disable LDAP functionality:
•To enable LDAP, select En
able LDAP.
• To disable LDAP, clear the En
able LDAP check box.
If you disable LDAP, single sign-on functionality
will not be available on the library.
3 To configure or modify LDAP, use the appropriate tabs and set the following
configurations:
General tab
• Serv
er Configuration section
• Primary: You
must provide a primary IP address or DNS
name.
• A
lternate: An alternate IP address or DNS name is optional.
• Secure
Use this check box to enable the setup options to access a
se
cure LDAP server, which can be done using any port
except 389. The default secure port is 636. If you enable this
option, you must retrieve the Trusted Root Certificate from
the server by clicking Retrieve TR.
• Po
rt: Enter the appropriate port in this field. The default port
for non secure connection is 389 – and 636 for secure (SSL)
based LDAP connections. The port setting can be changed.
• Retrieve TR: Use t
his function to retrieve the Trusted Root
Certificate from the LDAP server. A dialog box displays basic
Trust Root certificate information, for example, subject name,
MD5, and SHA 1 hashes. It is recommended that you verify
this information independently on the LDAP server.
The first time you use Retrieve TR, the process
can take 5 to 10 minutes. To connect to a secure
LDAP server, you must complete the retrieval
process.
Note
CAUTION