User`s guide

Chapter 4 Configuring Your Library
Setting Up the Network Configuration
Scalar i6000 User’s Guide 145
The primary Control Path Drive you selected is highlighted in
yellow.
5 Click OK.
Setting Up the Network Configuration
Make sure that your library is attached to the network before you use the
Network Configuration command.
1 Log on as an administrator.
2 If you are not already working from the physical library, select the
physical library from the View menu.
3 From the menu bar, click Setup > Network Configuration. Then,
depending on whether IPv6 is enabled or disabled and the protocol
of the network connection you want to configure:
• If IPv6 is disabled, the IPv4 Network Configuration dialog box
appears.
Proceed to Setting up IPv4 Network Configuration on page 146.
• If IPv6 is enabled, but you want to configure an IPv4 connection,
click IPv4 Configuration on the Network Configuration
submenu to display the IPv4 Network Configuration dialog.
Proceed to Setting up IPv4 Network Configuration on page 146
CAUTION
You must fully understand all network issues
before you change the network configuration for an
already configured library. It is recommended that
you consult with your network administrator before
changing your network configuration.
Note
To set up an iPv6 network connection, make sure
that the IPv6 option is enabled on the Physical
Library dialog, as described in Setting Up Policies
for the Physical Library on page 159.