User`s guide

Appendix C Installing the Scalar 50 Library
Emergency Library Access
Quantum Scalar 50 User’s Guide 213
4 For the network information such as the IP address to be active, you
must reboot the library by holding down the power button located on
the front of the library (see figure
117).
The library shuts down.
5 Pu
sh the power button to start the library.
The Scalar 50 tape library is initially configured and ready for use.
Emergency Library Access
Use the following procedure to gain access to the tape cartridge
magazines in case of an emergency and the library power is not available.
1 Pu
t on an antistatic wrist strap and clip it to the library chassis
(example: a captive screw on the tape drive cover plates).
Caution: Take standard ESD precautions whe
n performing this
procedure.
2 Inse
rt the door release tool included with the accessory kit into the
release holes and trip the magazine door release for both the right
and left magazine doors (see figure
122).
The magazine access doors open.