User's Guide

26 Installing Optional Hardware
2 From the rear of the Scalar 24, locate the available RMU slot. Loosen the thumbscrew on the cover plate
and remove the cover plate. Store the cover plate in a convenient place. It is required for proper
operation and cooling of the library if the RMU is ever removed.
3 Slide the RMU into position and tighten the thumbscrew.
The library detects the presence of the RMU. You must set the IP Address, Subnet Mask, and Gateway
Address before the RMU functions. You can do this through the Setup Wizard
on page 60 or Configure Net
Device on page 86.
Installing the Scalar 24 in a Rack
Your Scalar 24 can easily be converted to a rackmount configuration. Follow the steps below to install your
Scalar 24 into a rack.
Special care should be taken when installing a Scalar 24 into a rack. Heed the following guidelines:
• For continued safe operation, the recommended maximum internal ambient temperature of the rack
should not exceed 100
°F (38°C).