User's Guide

Scalar 24 Installation and Operation Guide 17
Connecting the Power Cord
Follow the procedure below to connect the power cord to your Scalar 24.
1 Make sure the power switch on the front of the library is off (the is pressed).
2 Plug the power cord into the AC receptacle on the rear panel of your Scalar 24.
3 Plug the power cord from the Scalar 24 into a grounded electrical socket.
Inserting Tape Cartridges
Make sure that the write-protect switch is set appropriately on each cartridge. Slide the switch to the
appropriate position by pushing it with your finger.
Follow the procedure below to insert data cartridges.
1 Open the media access door.
WARNING
USE CAUTION WHEN PLUGGING THE POWER CORD INTO AN
ELECTRICAL OUTLET. HAZARDOUS VOLTAGES ARE PRESENT IN
THE SOCKETS OF THE OUTLET.
CAUTION
Ensure that the AC line cord from the library is plugged directly into
the socket. Extension cords should not be used.