User's Guide

128 Using the Menus
Selection Description/Result
1 From the Tools menu, highlight and
press .
Runs Manufacturing test.
2 You are prompted with a warning, press
to continue the test.
CAUTION: This test moves your tapes
and may change your inventory
information by not replacing tapes in the
same locations.
3 Press and to select/deselect the I/E
slot.
Available options are:
• yes: includes the I/E slot in the tape swap
cycle
• no: does not load or unload a tape to the I/E
slot
4 Press to move to the next option.
5 Press and to select/deselect the
Drives slot.
Available options are:
• yes: allows loads and unloads to the drives
• no: does not load or unload tapes to the
drives
6 Press to move to the next option.
7 Press and to select the number of
Hours to run the manufacturing test.
You can choose between 0 and 72 hours.
8 Press to highlight Execute ( ) and
then press .
The Manufacturing test begins.