User's Guide
&KDSWHU
6FDODU$,7
When the tape drive is almost completely inside the slot, you will
feel some resistance. This is caused by the connection between the
tape drive and the library's controller card.
To seat the connection,
push firmly against the drive until you can push no further.
Tighten the captive screws on each end of the drive carrier faceplate.
6WHS²5HVXPHRSHUDWLRQV
Reconnect the power cord.
Close and lock the library's door.
Turn on the library. The library will take approximately one minute
to complete its power-on self-test.
1RWH
When you replace a tape drive, the new drive automatically
assumes the SCSI ID of the old tape drive. If you want to view
or change the SCSI ID of the new tape drive, see page 30.
&$87,21
7RDYRLGGDPDJLQJWKHWDSHGULYHPDNHVXUH
WKHOLEUDU\LVSRZHUHGRIIZKHQ\RXFRQQHFWLW
WRWKH6&6,EXV