User's Guide

7DSH'ULYH2SHUDWLRQ
,QVWDOODWLRQDQG2SHUDWLRQ 

Confirm that the cleaning was done by looking at the Status LED
on the front of the drive. The Status LED should be off. If the LED
is still on, replace the cleaning cartridge and clean the tape drive
again. If the LED is still on after the second cleaning, there may be
a problem with the tape drive.
³
,PSRUWDQW
,IWKHWDSHGULYHHMHFWVWKHFOHDQLQJ
FDUWU L GJHZL W KLQDPL Q XWH\ RXQHHGW RUHSOD FHWKH
FOHDQLQJFDUWULGJH6HHSDJH IRUFDUWULGJH
UHSODFHPHQWLQVWUXFWLRQV

When the cleaning is complete, return the library to its original
control mode (SCSI Interface mode or one of the sequential modes)
and re-enable security.
'LVSOD\LQJLQIRUPDWLRQDERXWWDSHGULYHV
From the operator panel, you can display information about the tape
drives, including the type of tape drive installed and its operational
status. The information screens are updated whenever there is a change
in drive status.
To display tape drive information: