User's Guide
/LEUDU\2SHUDWLRQ
,QVWDOODWLRQDQG2SHUDWLRQ
/&',QWHUIDFHPRGH
If you want to perform any operations from the operator panel that
involve moving the CHM, you need to set the library to LCD Interface
mode. All of these operations, such as cleaning the tape drives and
performing diagnostics, are included under the Maintenance Menu.
1RWH
LCD Interface mode is required only when you want to control
the motions of the CHM. For example, you do not need to switch
control modes to access the menus.
3LQPRGH
When the library is operating in 25/9-Pin mode, you can control the
motions of the CHM from a remote console program connected to the
library's 9-pin or 25-pin port.
1RWH
Use 25/9-Pin mode to control CHM motion only. You do
not need to change the control mode to access a tape drive's
firmware.
For more information about how to use the 25-pin and 9-pin serial ports,
see page 47.
&KDQJLQJWKHFRQWUROPRGH
Make certain the library is in the ready state (for example, no
hardware errors, the door is closed, and so on).
If the security option has been enabled, disable it (see page 32).
From the Main Menu, select Interface Menu.