User's Guide

/LEUDU\2SHUDWLRQ
,QVWDOODWLRQDQG2SHUDWLRQ 
2SHUDWLQJLQGLIIHUHQWFRQWUROPRGHV
To determine which interface will control CHM motion, you can set the
library to one of the following control modes:
S SCSI Interface
S Sequential 1
S Sequential 2
S Dual Sequential
S LCD Interface
S 25/9-Pin
These control modes allow you to operate the library with the application
software (SCSI Interface), operate the library as a sequential stacker
device (Sequential 1, Sequential 2, Dual Sequential), or perform
diagnostic functions on the library (LCD Interface, 25/9-Pin).
Refer to the following section for control mode descriptions. Refer to
page 47 for instructions on changing the control mode.
1RWH
Control mode settings remain through power cycles.