User's Guide

,QVWDOODWLRQDQG6HWXS
,QVWDOODWLRQDQG2SHUDWLRQ 
Step 4 – Set other configuration options
The Configuration Menu contains some other configuration options for
the library, as described in the table below. If desired, you can check
these settings and change them.
Configuration options
SCSI Parity* Allows you to enable parity checking for the library (if
the SCSI adapter card connected to the library supports
it). When enabled, the library checks all data on the SCSI
bus for parity. This remains in effect across power cycles.
Sequential
Options
Provides options for using the library’s sequential
modes. (See page 46 and Appendix K for more
information.)
Adjust Contrast Controls the brightness of the lettering on the LCD.
Back Light Turns the LCD background on or off.
Set Date Allows you to set the system date for the library. The date
appears on the Command History screen and on
diagnostic listings (see Chapter 6 for more information).
Set Time Allows you to set the time that is shown on the library's
Main Screen and in the Command History screen (see
Chapter 6 for more information).
Set Serial Number Allows you to make certain the serial number label on
the back of the library is also displayed in this screen;
and allows you to change the serial number. (The serial
number entered in this screen appears on diagnostic
listings; see Chapter 6 for more information.)
Use AIT Allows you to check whether an AI-T1 drive is installed.
This option is set at the factory.
Note:
If you want to
upgrade from an AIT-1 to an AIT-2 tape drive, contact
ADIC.