User's Guide

,QVWDOODWLRQDQG6HWXS
,QVWDOODWLRQDQG2SHUDWLRQ 
Step 5 – Close and lock the door
Close the door and turn the key a quarter-turn to the left.
Step 6 – Connect the library to the SCSI bus
This section provides general guidelines for connecting the library to the
SCSI bus. The library consists of three SCSI devices: the library itself
and the two tape drives. If a drive blank is installed, the library consists
of two SCSI devices (the drive blank is not addressable).
Before you begin
1.
Make certain the host computer and any peripheral devices are
turned off.
2.
If you are unfamiliar with connecting devices on a SCSI bus, first
read Appendix B.
3.
Determine the SCSI bus configuration (that is, how many SCSI
buses you will connect to the library and which bus you will connect
to which device).
4.
If you are connecting the library and two tape drives to a single bus,
install a jumper over the two inside connectors, as shown in the
example.
CAUTION
To avoid damaging the tape drives, make sure the tape
drives and library are powered off when you connect
the library to the SCSI bus.