User's Guide

Specifications

Installation and Operation



To that total, add the SCSI cable lengths used by the library

for each

bus

For each tape drive, add 23 cm (9 in) to allow for the cable used

by the tape drive inside the library.

For each jumper you plan to install on the library to connect

sequential devices to the same bus, add 5 cm (2 in.).

For the library, add 5 cm (2 in.) for the internal cable used by the

library itself.

Remote reset cable specifications

The remote hardware reset port on the back panel allows you to perform

a manual hardware reset on the library to clear hardware errors. This port

requires an 8-pin circular DIN connector and a two-wire cable capable

of providing momentary contact between pin 1 and pin 2.