User's Guide
7URXEOHVKRRWLQJ
,QVWDOODWLRQDQG2SHUDWLRQ
Termination
. Make sure your bus is properly terminated as
described in Appendix B. If another SCSI device previously
terminated the SCSI bus and is no longer at the physical end of the
bus, be sure to remove the terminators from that device.
Compatibility.
Make sure that your tape drive and library are
compatible with the SCSI adapter card and application software you
plan to use.
SCSI adapter card installation.
Make sure that you installed your
SCSI adapter card correctly. Refer to the documentation that came
with your card for installation and troubleshooting instructions. Pay
special attention to steps describing setting various jumpers and
switches on the card. Make sure that the card is properly seated.
Software installation.
Make sure that your application software is
installed correctly. Refer to the documentation that came with your
software. Pay special attention to steps describing configuring the
software for use with the library and tape drives.
Control mode.
Make certain the library is operating in the correct
control mode. For most applications, the control mode should be set
to SCSI Interface. See page 46 for more information.
After checking the items above, reset the library as described on page 56.