User's Guide

&KDSWHU
 6FDODU$,7
1RWH
An asterisk (*) indicates the current connection.
³
,PSRUWDQW
, I \ R X F R Q Q H F W D V H U L DO S R U W W R D W D S H 
GULYH\RXZLOOLQWHUUXSWDQ\6&6,FRPPDQGV
EHLQJVHQWWRWKDWGULYH

Select one of the options listed below:
S Connect to Drive 1 (closest to the magazine)
S Connect to Drive 2 (farthest from the magazine)
S Diag Console (the library's diagnostic firmware)

When you have selected the option you want, press
>(QWHU@
. The
system configures the port and displays a confirmation message.
Press
>(VFDSH@
to exit this message.

Press
>

@
to assign one of the baud rates to the port and press
>(QWHU@
.
An asterisk (*) indicates the current connection. (Use 9600 baud to
connect to a tape drive.)
If you selected Connect to Drive 1 or Connect to Drive 2 to perform tape
drive diagnostics, be aware of the following:
S The library changes back to the default setting, Diag Console, after
the library door has been opened and closed or after the library has
been reset.
→
* C o n n e c t D r i v e 1
C o n n e c t D r i v e 2
D i a
g
C o n s o l e
B a u d R a t e : 1 2 0 0
↓