Operating instructions

Using the Remote Management Unit 3-19
September 2007
Synchronizing with an NTP Server
You can connect the RMU to a network time (NTP) server to
automatically set the time.
Step 1 Click the Configuration tab.
Step 2 In the Date and Time area, select ON from the
Synchronization with NTP Server drop-down
menu.
Step 3 In the NTP Server IP Address field, enter the IP
address of the NTP server.
Step 4 In the Timezone field, enter the time zone deviation
for the NTP server. To get a list of timezone offsets,
click list of timezones.
Step 5 Click Submit and review your changes (indicated
in red).
Step 6 Enter your password and click Confirm to
complete the procedure.
Updating Firmware
You can update firmware for the RMU. Before you update
firmware, you need to have the firmware file in a location that
is accessible from the RMU interface. Firmware updates can
be found on www.
quantum.com.
Step 1 Click the Firmware tab.
Step 2 Select the firmware you would like to update.
Step 3 Click Browse and browse to the location of the
firmware update file.
Step 4 Click Update Firmware.
The firmware updates. If the RMU was selected for
a firmware update, the RMU will reboot.
Note
If using a time
server, the
Scalar 10K
synchronizes
with the RMU.
Note
Downloading
firmware can take
several minutes.