Operating instructions

Using the Remote Management Unit 3-15
September 2007
Configuring Network Parameters
You can reconfigure the hostname, IP address, subnet
mask, and gateway address through the RMU. This feature
requires you to log in to the RMU. Refer to Accessing and
Logging Into the RMU on page 4-13 for more information.
Step 1 Click the Configuration tab.
Step 2 In the Network Configuration area, enter the new
hostname, IP address, subnet mask, and gateway
address.
Step 3 Click Submit and review your changes (indicated
in red).
Step 4 Enter your password and click Confirm to
complete the procedure.
The new values are saved. Note that you may need
to redirect your Web browser if you are logged out.
Configuring SNMP
Simple Network Management Protocol (SNMP) is a set of
protocols used to manage nodes on an IP network. You can
configure the RMU to send alerts to and respond to requests
from an SNMP management application.
To ensure event capturing and reporting, you must enable
SNMP and enable the SNMP alerts.
Step 1 Click the Configuration tab.
Step 2 In the SNMP Configuration area, do the following:
• To enable or disable the feature, select ON or
OFF in the SNMP Enabled drop-down.
• To enable or disable SNMP alerts, select ON or
OFF in the Alerts Enabled drop-down. SNMP
must be enabled if you want SNMP alerts
enabled.
•In Manager, enter the SNMP server address.