Operating instructions

Frequently Asked Questions 6-43
September 2007
Question: How do I remove a tape?
Answer: There are several ways to remove tapes from the
Scalar 10K. Refer to Inserting Tape Cartridges on
page 5-6.
Question: Where are the drives located?
Answer: Drives are located in the Control Module or in the
Drive Module. Refer to Control Module on page 2-
6, Drive Module on page 2-7, Figure 2-3 on page
2-9, Figure 6-1 on page 7-13, and Figure 6-2 on
page 7-14.
Question: How do I set the SCSI/Loop ID’s on the Universal
Drive Sled (UDS) drives?
The default ID is set for each drive during the
installation but can be changed if needed. It is
recommended that you keep the default ID’s.
Answer: SCSI/Loop ID’s can be set via the operator panel.
Refer to ID Dialog on page 4-88.
Question: Where are the Error Messages defined?
Answer: The Error Messages are defined in the last
chapter in this guide. Refer to Service Action Codes
on page 6-11, Error Log Form on page 6-41, and
Error Log Form on page 6-41.
Question: How do I get help?
Answer: Refer to Getting More Information or Help on page
1-8.