Operating instructions

6-38 Error Messages
6-00058-05 Rev A
F2 00 00 Failures were detected while running the diagnostic loop test from the LSC
card to the LGR card.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
F3 00 00 Failures were detected while running the diagnostic loop test from the LSC
card to all the sensors on the Gripper assembly.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
F4 xx yy Failures were detected while running the diagnostic loop test from the LSC
card to all the sensors on the Insert/Eject station.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
F5 00 00 Failures were detected while running the diagnostic loop test from the LSC
card to the X-axis home sensors.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
F6 00 00 Failures were detected while running the diagnostic loop test from the LSC
card to the Y-axis home sensor.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
F7 00 00 Failures detected in the LSC card during Power On Self Test.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
F8 00 00 Failures detected in the LMC card during Power On Self Test.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
Table 6-2 Service Action Codes (Continued)
Reported
SAC
Perform these actions