Operating instructions

Service Action Codes 6-27
September 2007
80 00 00 Failures detected in the X-axis servo system.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
81 00 00 Failures detected in the Y-axis servo system.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
82 00 00 An unexpected Motor Control condition was received.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
83 00 00 The Locate Fiducial Command failed with no target found. This failure
happens most likely during an initial installation of the Library
Subsystem.
Action 1
Run Teach New from the operator panel (Main Menu Service Teach
Teach New).
Action 2
If the problem is not corrected or persists, contact GCH. For GCH contact
information, refer to Getting More Information or Help on page 1-8.
84 00 00 Y-axis failed to reach target.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
85 00 00 X-axis failed to reach target.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
Table 6-2 Service Action Codes (Continued)
Reported
SAC
Perform these actions