Operating instructions

Service Action Codes 6-23
September 2007
60 xx yy Cannot complete the Lock/Unlock Insert/Eject station commands.
Action 1
Use the modifier xx yy to locate the Insert/Eject station:
• xx = rack number (1 to 16)
• yy = Insert/Eject station number (1 to 4)
For more information on SAC modifiers, refer to Service Action Codes on page
6-11.
Action 2
Make sure that the door (identified by xx yy) is properly closed. For the
location of Insert/Eject stations, see Figure 2-1 on page 2-3.
Action 3
If the problem is not corrected or persists, contact GCH. For GCH contact
information, refer to Getting More Information or Help on page 1-8.
61 xx yy The Insert/Eject Station Closed Sensor error threshold is exceeded.
Action 1
Use the modifier xx yy to locate the Insert/Eject station:
• xx = rack number (1 to 16)
• yy = Insert/Eject station number (1 to 4)
For more information on SAC modifiers, refer to Service Action Codes on page
6-11.
Action 2
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
62 xx yy A down level LIE card was detected by the library firmware when a newer
version is required for this library configuration to operate.
Action 1
Use the modifier xx yy to locate the Insert/Eject station:
• xx = rack number (1 to 16)
• yy = Insert/Eject station number (1 to 4)
For more information on SAC modifiers, refer to Service Action Codes on page
6-11.
Action 2
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
Table 6-2 Service Action Codes (Continued)
Reported
SAC
Perform these actions