Operating instructions

6-22 Error Messages
6-00058-05 Rev A
47 xx yy During a Get or Put operation, the calculated Y position exceeded the
allowable limits.
Action 1
Note the location of the storage assembly or magazine as indicated in the SAC
modifiers xx and yy:
• xx: rack number (1 to 16)
• yy: section number within a rack or I/E Station (1 to 5)
For more information on SAC modifiers, refer to Service Action Codes on page
6-11.
Action 2
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
48 00 00 Aisle Fuse has opened.
Action 1
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
49 00 00 Top and bottom X-axis motors are different types
Action 1
The top X-axis motor and bottom X-axis motor are required to be the same
type. The library firmware verifies that both motors are the same type. If they
are not the same type, a SAC 49 is posted and the library will not go ready.
Action 2
Contact GCH. For GCH contact information, refer to Getting More Information
or Help on page 1-8.
50 00 00 A cartridge is not properly seated in the storage cell.
Action 1
Do the following:
1. Check the location of the gripper.
2. Make the library not ready.
3. Open the service door.
4. Verify the location of the cartridge and check it for damage.
- If the cartridge is not damaged, put the cartridge in the storage cell and
check for correct seating.
- If the cartridge is damaged, remove the cartridge from the system.
5. Inspect the storage location or drive for visible damage.
6. Contact GCH. For GCH contact information, refer to Getting More Infor-
mation or Help on page 1-8.
Table 6-2 Service Action Codes (Continued)
Reported
SAC
Perform these actions