Operating instructions

5-22 Processing Media
6-00058-05 Rev A
AutoClean
The host should not share Scalar 10K controlled cleaning
media. If a host does share the Scalar 10K firmware controlled
cleaning media, the Scalar 10K firmware does not change or
update cleaning media usage information.
Use this procedure to set autoclean. For more information,
refer to Drives Dialog on page 4-96.
Step 1 From the operator panel Main Menu, select
Setup Cleaning.
The Cleaning Submenu appears. See Figure 5-23.
Figure 5-23 Cleaning Submenu
Step 2 Select Drives.
The AutoClean dialog appears. See Figure 5-24.
Figure 5-24 AutoClean Dialog
Step 3 Select AutoClean, set the schedule (immediate or
delayed), Hours, Min (time to start the cleaning),
Accept.
Immediate - every dismount causes the firmware to
check for a cleaning request from the drive and
cleans the drive immediately.
Delayed - sets the cleaning process time by setting
the Hour and Min option values.
If the firmware receives a clean drive request, the
dismount response holds until the cleaning process
is complete. It is recommended that the host extend
the timeout period normally associated with
waiting for a dismount response.
>Drives...
Media...
View...
AutoClean: Y<
Schedule: Delayed
Start Time: 10:45
Accept: N
Note
The Delayed option
should be initiated
during routine or
normal downtime
because the Scalar 10K
goes NOT READY for
the duration of the
cleaning operation.