Operating instructions

Cleaning Drives 5-19
September 2007
Insert a Cleaning Cartridge
This procedure describes how to insert a cleaning cartridge.
For more information, refer to Insert Clean Tape Dialog on page
4-53.
Step 1 From the operator panel Main Menu, select
Commands Insert/Eject Insert Clean Tape.
The Insert Clean Tape Dialog appears. See Figure 5-15
on page 5-19.
Figure 5-15 Insert Clean Tape Dialog
Step 2 Enter the source Coord, Index, and Accept.
The Insert Range Dialog appears. See Figure 5-16.
Figure 5-16 Range Dialog
Step 3 Enter the number of cleaning cartridges in the I/E
station (Insert Range), and Accept.
The Target Dialog appears. See Figure 5-17.
Figure 5-17 Enter Target Dialog
Step 4 Enter the Target Coord (the starting address for
inserting cleaning cartridges), Index, and Accept.
Note
It is possible to
use the I/E
station as storage
for cleaning
media but is not
recommended.
Enter SOURCE
Coord: I 01< 1 A 01
Index: IE 00001
Accept: N
Insert Range: 01<
Accept : N
Enter TARGET
Coord: S 01 1< A 01
Index: ST 00001
Accept : N