Operating instructions

4-134 Menus and Commands
6-00058-05 Rev A
The fourth field indicates the
column of the section (A–P)
The fifth field indicates the
row of the column (01–15)
Index The device address associated
with the selected coordinate
parameter:
DT = data transfer device
IE = insert/eject device
ST = storage device
Accept Y to accept
N to reject
If Y is selected, the Number of Drives Dialog appears. See
Figure 4-202. Otherwise, the changed parameters
continue to display but no action is taken.
Figure 4-202 Number of Drives Dialog
Number of Drives refers to possible drive slot locations, not
the actual number of drives that exist. If the source coordinate
is D 01 1 A 01, and 12 is entered at the Number of Drives
screen, any drives that are present in drive bay 1 and loaded
with a cartridge will be included in the test. Twelve is the
maximum number of drive slots available in drive bay 1.
Parameters Description
Get/Put Selects the number of drives to
apply the Get/Put operation
(0000–0648 for all drives)
Accept Y to accept changes
N to reject changes
If Y is selected, the Response Dialog appears. See
Figure 4-203. Otherwise, the changed parameters
continue to display but no action is taken.
Number of Drives
to Get/Put :0010<
Accept : N
Note
Counts forward
from the selected
drive position to
the last drive
position. Does not
count any drives
prior to the selected
drive position.