Operating instructions

Setup Menu 4-89
September 2007
Parameters Description
Drive Drive number and coordinate
position
ID Current SCSI/Loop ID of the
drive
New ID New SCSI/Loop ID of the
drive
Port Fibre channel port number.
Not applicable for SCSI drives.
Accept Y to accept changes
N to reject changes
If Y is selected and you are using SCSI drives, the SCSI
Drive Selection screen reappears.
If Y is selected and you are using fibre channel drives, the
Continuation Screen appears. See Figure 4-127.
Figure 4-127 Continuation Screen
Parameters Description
Drive Drive number and coordinate
position
Speed Data rate (Auto, 1 GB, 2 GB)
Auto: The library auto
negotiates the data transfer
rate.
1 GB: 1 Gigabit/sec
2 GB: 2 Gigabit/sec
Topology Method of connecting to fibre
(Auto, Loop, Nport)
Port Fibre channel port number
Accept Y to accept changes
N to reject changes
If Y is selected and you are using single port fibre channel
drives, the Fibre Drive Selection screen reappears.
Note
Drive changes do not take
place until the drive is
activated.
Drive: DT00010
Speed: Auto
Topology: Auto
Port : 1 Accept:N