Operating instructions

4-84 Menus and Commands
6-00058-05 Rev A
More Submenu
Path: Main Menu Setup Library More
Use the More Submenu to view and change the advanced
configuration, calibration, or cartridge parameters and the
inventory parameters for the library. See Figure 4-121.
Figure 4-121 More Submenu
Depending on your selection, refer to:
• Advanced Dialog below
• Inventory Dialog on page 4-86
Advanced Dialog
Path: Main Menu Setup Library More Advanced
Use the Advanced Dialog to enable or disable the automatic
configuration, calibration, or cartridge scan when the library
power has been cycled. See Figure 4-122 on page 4-84.
If Auto Inventory is disabled, the element status is not
known until the host issues an Initialize Status command or
an Inventory is performed via the operator panel.
If Auto Inventory is enabled, an automatic cartridge
inventory is executed on each power cycle.
Any changes in the Operating Mode parameter value
should be made by authorized Service Personnel. The
default is set to 2.
Figure 4-122 Advanced Dialog
>Advanced...
Inventory...
Auto Teach :Y<
Auto Inventory:N
Operating Mode:00
Accept: N