Operating instructions

4-44 Menus and Commands
6-00058-05 Rev A
Position Scanner Dialog
Path: Main Menu Commands Move Position Scanner
Use the Position Scanner to move the scanner to a specific
element. See Figure 4-52.
Figure 4-52 Position Scanner Dialog
Parameters Description
Coord The first field indicates the
type of cell (I for I/E Station, D
for Drive, S for Storage cell)
The second field indicates the
rack number (01–16)
The third field indicates the
storage cell section (1– 5)
The fourth field indicates the
column of the section (A–P)
The fifth field indicates the
row of the column (01–15)
Index The device address associated
with the selected coordinate
parameter:
DT = data transfer device
IE = insert/eject device
ST = storage device
Accept Y to accept
N to reject
If Y is selected, two Response Screens appear. See
Figure 4-53 on page 4-45 and Figure 4-54 on page 4-45.
Otherwise, the changed parameters continue to display
but no action is taken.
Enter TARGET
Coord: S< 01 1 A 01
Index : ST 00001
Accept: N
Note
The Coord: S
cannot be changed
to Coord: I, if
magazines are not
installed in the I/E
station.