User's Guide

RDX 8000
83
5. Select Jumbo Packet (or Jumbo Frame) in the Property List. Set the value to 9000. Click OK.
6. If your Property List does not include Jumbo Packets/Frames (as in the example below), you will need to
update the driver for the network card. Check the network card manufacturer website for the latest drivers.
7. On the Connection Properties Box for the network port, select the Internet Protocol 4 (IPv4) and click Properties.
8. Click “Use the following IP Address” and enter an IP address for the port. Make sure at least one of the first 3
sets of numbers of the IP address is different from the IP address of the primary port. For example, if the
primary IP address is 192.168.32.10, the second port could be configured to 192.168.64.10. In this example,
do not configure the second port to 192.168.32.12. Configure network mask and gateway. Click Ok.
9. Connect RDX 8000 to primary network that the server’s primary network port is connected to and power up.
After boot-up the DHCP assigned IP address will be displayed in OCP.
10. Log into RDX 8000 using the browser on the server. Use username administrator and password adm001