User's Guide

RDX

8000

3. RDX 8000 Jumbo Frames configuration

Optimum RDX 8000 performance can be achieved in all operating Modes (JBOD and Tape Library) through a Jumbo

Frames configuration. As all network data devices need to be configured for Jumbo Frames for proper operation and

performance, the recommended configuration is using a second network port on server configured for a static IP and

Jumbo Frames (MTU9000) and connecting the RDX 8000 to the server using a cross-over cable or a jumbo-frames

capable gigabit network switch.

Procedure:

Please note: This procedure assumes an available 2

network port on the server, and an available temporary

connection to the primary network with DHCP service. This example procedure is using Windows Server 2008 R2,

but can be configured on other operations systems.

1. On the server, go to Control Panel – Network and Internet – Network Connections. You should see two

network connections, one active and one not connected.

2. Right-click on the unconnected network port. Select Properties.

3. Click on Configure.

4. Select the Advanced tab.