User's Guide
78
RDX
8000
2.
CRU
replacement
2.1 Power supply
The power supply is a
CRU
(Customer
Replaceable
Unit). The power supply is located on the rear side of the unit and
is fixed with two thumb
screws.
The power supply is capable to power up to 8 cartridges simultaneously while
supporting
other unit electronics (controller,
LED`s, OCP,
motors).
For technical specification,
see
section “1. Product specification” on page 75.
2.1.1
Removing
a power supply
1. Power down the unit by pressing the power button on the front panel.
2.
Locate
the
power
supply
on
left
side
on
the
rear
panel
of
the
RD
X
8000
unit,
shown
in
section “3.1
Rear
panel
layout” on page
10
.
3. Remove the power cord on the rear panel of the
unit.
4. Loosen the two thumbscrews located on the rear of the power supply using a #3 Phillips screwdriver or
your
fingers.
5. Pull the power supply straight out of the
unit.
6. To store or ship the removed power supply,
repackage
it in the original or replacement device packaging
materi
als.
2.1.2 Installing a power supply
1.
Locate
the
power
supply
bay
on
left
side
on
the
rear
panel
of
the
RD
X
8000
unit,
shown
in
section “3.1
Rear
panel
layout” on page
10
.
2. Before installing the power supply, inspect the connectors on the power supply.
Ensure
that the connectors
are intact, free of any foreign objects, and have no
cracks
or deformed or bent contacts.
3. Insert the power supply on the alignment rails and push the power supply into the power supply bay until it
seats itself against the back of the
unit.
Figure 54 — Installing a power supply
1.
2.
3.
4. Tighten the two thumbscrews using a #3 Phillips screwdriver or your fingers to secure the power supply to
the
unit.