User's Guide

20
RDX 8000
5.3.1 OCP Display Content
Once the
RDX 8000 unit completes the power up boot sequence the OCP will become active. The OCP will display the
system information screen which identifies the unit’s iSCSI QN name, current IP address / status of Ethernet port 1,
as well as the unit current firmware revision level.
The normal display mode rotates through nine
screens. The System Information screen is followed by eight
individual screens indicating slot status. Following slot 8 the rotation is repeated, beginning with the System
Information screen.
After initial power up the
OCP will hold on the System Information screen. The OCP may be set to automatically
rotate through all screens by pushing and holding the OCP Navigation button for three seconds (long push).
The general layout of the Slot Status screen is shown in the figure below:
Cartridge Serial
Number
Cartridge
W rite
Cartridge
Health
CARTRIDGE S/N:
XXXXXXX
Cartridge Eject Prevented
OCP Navigation
Slot
Number
Figure 7 —
OCP S lot Status
Cartridge
Format