User's Guide

16
RDX 8000
4.2 Installing in a r ack
NOTICE
First read Section “14” on page 14. If the unit will not be r ack-mounted, skip to
“4.3 Installing cables and connections” on page 17.
Required tools:
• #3 Phillips screwdriver
Rack mounting the RDX 8000:
1. Determine the location in the rack for the unit to be
installed.
2.
Use a pencil to mark the location on each vertical rail in the rack.
3. Install the rack ears of the unit using
T10 Torx screwdriver to tighten the Torx screws included in the rack
mount kit.
Figure 4 — Installing the rack ears
4. Locate and install appropriate clip nuts into rack
r ails.
5.
Secure the unit to the rack using a #3 Phillips screwdriver or your fingers to tighten the two captive thumb
screw(s) on each side of the unit.
Figure 5 — Securing the unit to the rack