User's Guide

14
RDX 8000
4.1.2 Installation precautions
Select a location that meets the following criteria:
CAUTION
Static sensitive
Risk of damage to devices
• A discharge of static electricity damages static-sensitive
devices or micro
circuitry.
• Proper packaging and grounding techniques are
necessary precautions to
prevent damage.
NOTICE
• Do not expose the unit to moisture.
• Use the unit on a firm level surface free from vibr ation.
• Do not place anything on top of the unit.
4.1.3 Unpacking the
unit
Before unpacking the unit, clear a work surface to unpack the
RDX 8000. Select either a table top location or if the
unit is to be rack mounted an open rack location at least 2U
spaces in vertical height.
Make sure that the intended operating location provides
access to the network connection(s) which will be used and
an
accessible AC power outlet within 6 ft. of the unit.
NOTICE
If the temperature in the room where the unit will be installed varies by 15º C
(30º F ) from the room where the unit was stored, allow the unit to acclimate to
the surrounding environment for at least 12 hours before unpacking it from the
shipping container.
Unpacking the RDX 8000:
1. Before opening and removing the
RDX 8000 from the box, inspect the container for shipping damage. If you
notice any damage, report it to the shipping company
immediately.
2. Open the
RDX 8000 over pack bo x.
3. Carefully remove the
accessory tray and shipping materials from the top of the over pack bo x.
4.
Remove the inner box containing the RDX 8000.
5. Open the
RDX 8000 bo x.
6. Lift the
RDX 8000 out of the carton and remove the bag from the unit.
7.
Save the packaging materials for future use.
NOTICE
Do not place the unit on either end or sides as this may damage the unit.