User's Guide

Chapter 4 Service Commands
Initializing Non-Volatile Information
Quantum P4000 and P7000 Libraries User’s Guide 83
4 When you have selected the type of test and all test options, press the
Execute button.
A “Command In Progress” dialog box is displayed.
The system test continues until completed unless you press the
Abort
button. If you pressed the
Continuous button in step 3, you must
press the
Abort button to stop the test.
Initializing Non-Volatile Information 4
The
Service screen contains two commands involving information stored
in nonvolatile memory:
• Initialize nonvolatile memory configuration—returns the library
configuration to its factory-default condition, eliminating any
changes made using the Configure Library and Configure Options
commands in the Operator screen and invalidates the calibration
data.
• Initialize nonvolatile memory statistics—purges nonvolatile memory of
all statistical information about library operation. This information is
used to generate the statistical report described on page 76
.
Executing Either
Command 4
To execute either command:
1 On the
Service screen, press the button that corresponds to the
command you want to execute. The GUI displays a dialog box
prompting you to Continue or Cancel the command.
Caution: The following two commands are meant to be used only
by qualified, Quantum-trained personnel. They are
presented here for explanation only. Serious operational
problems and data loss may occur if you do not fully
understand the consequences of these commands.