User's Guide

Chapter 4 Service Commands
Initializing Non-Volatile Information
64 Quantum|ATL P3000 Series User’s Guide
Initializing Non-Volatile Information
4
The Service screen contains two commands involving information
stored in nonvolatile memory:
• Initialize nonvolatile memory configuration—returns the library
configuration to its factory-default condition, eliminating any
changes made using the Configure Library and Configure
Options commands in the Operator screen and invalidates the
calibration data.
• Initialize nonvolatile memory statistics—purges nonvolatile
memory of all statistical information about library operation.
This information is used to generate the statistical report
described on page 58
.
Executing Either
Command
4
To execute either command:
1
On the Service screen, press the button that corresponds to the
command you want to execute. The GUI displays a dialog box
prompting you to Continue or Cancel the command.
2
Press Continue. A “Command in Progress” dialog screen is
displayed.
Caution:
The following two commands are meant to be used
only by qualified, ATL-trained personnel. They are
presented here for explanation only. Serious
operational problems and data loss may occur if you
do not fully understand the consequences of these
commands.
Note:
If it becomes necessary to abort the command, press
Cancel.