User's Guide

Chapter 4 Service Commands
Testing the Library
62 Quantum|ATL P3000 Series User’s Guide
Figure 35 Report:
AutoClean Status
Screen
When you have finished reviewing the report, press the Back
button to return to the Service screen.
Testing the Library
4
The Service screen provides a testing command:
• SysTest—this command tests library operation by swapping
tape cartridges between storage bins or drives.
Performing a
System Test
4
To perform a system test:
1
From the Service screen, press the SysTest Library button.
Caution:
This screen is meant to be used only by qualified,
ATL-trained personnel. It is presented here for
explanation only. SysTest will alter inventory
information.
Back Forward
Home
S
Report: AutoClean Status
Auto Clean Enabled: FALSE
Auto-Clean State: Idle
Cleaning Operation Count: 0
Bad Operation Count: 0
Untracked Operation Count: 0
Last to Drive Error Status: 0 00 00
Last to Load Port Error Status: 0 00 00
Last to Home Error Status: 0 00 00
System
Off-line
Standby
Load Port
Stop
About
Service
Tapes
Operator
Quantum|ATL