User's Guide

Chapter 3 Operator Commands
Moving Cartridges
Quantum|ATL P3000 Series User’s Guide 51
Figure 27 Control:
Move Cartridges
Screen
2
Identify the source element of the cartridge to be moved.
Proceed as follows:
a
Press the appropriate source element button (Storage Bin,
Tape Drive, Load Port, or Gripper). When you press an
element type, the Range field (below the Destination field)
displays the range of addresses .
b
Using the keypad, enter the address of the source element
and then press the Destination input field. The Source
information is displayed in the Source field and the
Destination field becomes active.
3
Identify the destination for the cartridge:
a
Press the appropriate destination element button (Storage
Bin, Tape Drive, Load Port, or Gripper).
System
Off-line
Standby
Load Port
Overview Tapes Operator
Back Forward
Home
O
Control: Move Cartridge
Select
Execute
Gripper
9 0
7 8
5 6
3 4
1 2
Stop
Storage Bin
_
Source:
Drive
Destination:
Load Port
Range:
PTM
About
Quantum|ATL
Backspace button:
Use this button to erase a partial
entry - character by character