User's Guide

Chapter 3 Operator Commands
Moving Cartridges
50 Quantum|ATL P3000 Series User’s Guide
2
Press the Abort button to stop continuous running of the
inventory process, otherwise, the process will continue until all
storage elements have been inventoried.
Moving Cartridges
3
The Move Cartridges command allows you to move any tape
cartridge in the library to the destination you specify. This
destination can be a storage bin, a tape drive, the load port, or the
gripper.
To move a cartridge:
1
In the Operator screen, press the Move Cartridges button.
The GUI displays the Control: Move Cartridges screen, with
the Source input field active (see figure 27
).
Note:
The inventory process is also stopped if an error is
detected. In this case, the GUI displays an error
message.
Note:
To move a cartridge from a tape drive, issue an Unload
Drive command as explained in “
Unloading a Drive.”