User's Guide

Chapter 2 Basic Library Operations
Using the GUI
24 Quantum|ATL P3000 Series User’s Guide
3
Verify that the CHM is empty by checking the Overview screen
on the GUI (see chapter 3,
Operator Commands).
If there is a tape cartridge in the CHM, perform a Move
command to place the cartridge in an available bin.
4
Turn off the power switch located below the GUI.
Using the GUI
2
The GUI is activated by touching the screen, and is located on the
front of the library. The menus displayed on the GUI allow you to
obtain information about the library, execute library commands,
and test library functions (see figure 12
).
The GUI’s functions are grouped into the following four screens:
• Overview screen—displays current tape drive, CHM, and load
port content and activities.
• Tapes screen—displays tape drive, storage bin, load port, and
gripper inventories.
• Operator screen—contains library configuration and control
functions (password protected).
• Service screen—contains reporting functions, system tests, and
service commands (password protected).
• Multi-Unit screen—contains multi-unit configuration and
calibration.
Note:
Wait ten seconds before turning on the power switch
again.