User Manual

Maintenance
EVQROCM-01-V03-R0 Installation and Operation Manual Quantum:EV OpenCharge
January 2022 Page 22 of 25
Suggested Inspection and Testing
A record or inspection, testing and maintenance should be kept and may be required to
support any claims within the warranty period.
1
st
and 3
rd
Quarter
External Visual Inspection:
x Check for physical damage.
x All warning labels present and
legible.
x Status Indicators operating and
displaying correct status.
x If installed, check the condition of
the charging socket, contacts and
socket flap.
x If installed, make sure the
access/cable lock is operational.
Internal Visual Inspection:
x Check for physical damage.
x Visual inspection for any heat
degradation.
x No foreign bodies or other
contamination present.
Clean the enclosure.
2
nd
and 4
th
Quarter
External Visual Inspection:
x Check for physical damage.
x All warning labels present and
legible.
x Status Indicators operating and
displaying correct status.
x If installed, check the condition of
the charging socket, contacts and
socket flap.
x If installed, make sure the
access/cable lock is operational.
Internal Visual Inspection:
x Check for physical damage.
x Visual inspection for any heat
degradation.
x No foreign bodies or other
contamination present.
Electrical:
x Make sure wires/terminals are
secure.
x Check Voltage and Polarity.
x Check operation of RCDs and
RCBOs.
x Test earth fault loop impedance.
x Test power outlets using a load
simulator.
x If illumination is installed, check
that the illumination and light
sensor operates correctly.
Clean the enclosure.
Quarterly Inspection and testing (maintenance) is recommended where charger use
is frequent and/or intensive. Operators may consider increasing or reducing the
maintenance frequency to level that matches the pattern of charger use but should,
as a minimum, perform the tasks in the right-hand column on an annual basis.