Quantum ATL M2500 Unpacking Instructions Introduction 3 Removing the Library from the Shipping Carton 3 Removing the Remaining Packing Materials 10 Checking the Contents 21 Document 6423000-04 A01, May 2003 1
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 2 6207947-05fN 11
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 Introduction 0 This document explains how to unpack the ATL M2500 library. Warning: This document is provided as a reference only. This product requires professional installation by Quantumauthorized personnel. Non-authorized personnel should not attempt unpacking or installation. Improper installation may result in service charges or may invalidate your product warranty.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 3 Carefully cut the two plastic straps securing the shipping carton to the pallet (see figure 1). Caution: The straps are under tension and snap away when cut.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 4 Lift the lid off of the shipping carton (see figure 2).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 5 Cut the adhesive tape securing the upper tray and lift it off (see figure 3). 6 Remove the rack mount shelf box and set it aside (see figure 3).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 7 Remove the packing foam from the top of the library and set them aside (see figure 4).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 8 Fold down the front of the lower tray and remove the front packaging piece from the lower cushion assembly (see figure 5). Warning: The library weighs approximately 152 lbs. (69 kg). At least two people are required to lift and install the library. Caution: Lift the library by its sides, not by the front bezel.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 10 Remove the straps securing the shipping panels to the sides of the library (see figure 6): a Pull down on the strap tension ratchets to loosen the straps. b At the top of the library, unhook the straps. 11 Remove the accessory boxes from the sides of the library and set them aside (see figure 6).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 c Set the panel aside. d Repeat steps 12a through 12c on the other side to remove the left shipping panel. Shipping panels Figure 7 Removing the Shipping Panels Removing the Remaining Packing Materials 0 Now that you have removed the library from its shipping carton, remove the remaining packing materials from the library: 1 Remove the transit screw from the top of the library and set it aside (see figure 8).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 Transit screw Figure 8 Removing the Transit Screw 2 Put on an antistatic wrist strap and clip it to the antistatic stud on the back of the library. 3 Press the buttons next to the three magazine access doors and open the doors. 4 Remove the four pieces of packing foam from the front of the magazines (see figure 9).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 Left magazine access doors Figure 10 Magazine Access Door Buttons Left magazines Magazine access door buttons Right magazines Right magazine access door Level 1 Level 2 Level 3 Level 4 5 Remove the level 1 left magazine: a Grasping the handle at the front of the level 1 left magazine, pull it forward until it stops. b If the magazine stops after the first slot, perform steps 5c through 5e to release it.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 d Reach into the library underneath the level 1 left magazine and pull down on the release latch (see figure 12). Figure 12 Release Latch Release latch e While holding the release latch, pull the level 1 left magazine forward and out of the library (see figure 13).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 6 Remove all remaining magazines by grasping the handle at the front of each magazine and sliding it forward and out of the library. Caution: When reaching into the library through the magazine access doors, be careful not to exert pressure on the magazine shelves. Excessive pressure may bend the shelves.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 8 Remove the robotic hand pad assembly: Reach through the open right magazine access door and to the left. Grip the steel flange on the “Y” slide and push it toward the back of the library. a Caution: b Avoid touching the printed circuit board and its ribbon cable connector.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 9 Using a flat blade screwdriver, remove the two transit screws securing the back of the X-Y tray to the floor of the library (see figure 16).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 10 Place the transit screw (which you removed in step 1) and the transit screws on the X-Y tray (which you removed in step 9) in their storage locations at the base of the level 4 left magazine slot (see figure 17).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 11 If the library will be installed in a rack with a StackLink mechanism, remove the StackLink cover plate from the library. Caution: a Do not remove the StackLink cover plate if the library will be used as a stand-alone unit. Insert a flat blade screwdriver into the horizontal Z movement slot and turn the screw counterclockwise to raise the Z tray to level 1 (see figure 18).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 b Reaching into the library through the bottom right magazine location, use a T-20 TORX screwdriver to remove the screw at the top right corner of the StackLink cover plate (see figure 19).
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 c Lift the cover plate up to disengage the bottom flange of the cover plate from the bottom edge of the StackLink opening (see figure 20). d Remove the cover plate from the library.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 12 Carefully check the library for any foam debris. If any debris is present, remove it. 13 Replace all of the magazines. 14 Close the magazine access doors. The library is now unpacked and ready to be installed in its final location. Refer to the Quantum ATL M-Series Library Installation Guide (6423001) for installation instructions.
Quantum ATL M2500 Unpacking Instructions Document 6423000-04 A01 May 2003 22 Checking the Contents
