Quantum ATL M1500 Unpacking Instructions Introduction 3 Removing the Library from the Shipping Carton 3 Removing the Remaining Packing Materials 5 Checking the Contents Document 6421002-06 A01, July 2003 10 1
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 2 6207947-04fN 5
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 Introduction 0 This document explains how to unpack a Quantum ATL M1500. The unpacking procedure consists of the following major steps: • Removing the library from the shipping carton • Removing the remaining packing materials • Checking the contents Removing the Library from the Shipping Carton 0 To unpack the library: Note: Be careful not to damage the packaging materials while unpacking the library.
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 Figure 1 Removing the Library from the Shipping Carton Lid Accessories kit Library Shipping carton Pallet Plastic straps 5 Remove the accessories kit and set it aside. 6 With the help of a second person, lift the library up and out of the shipping carton. Warning: The library weighs 54 lbs (24.5 kg). At least two people are required to move the library. Caution: Lift the library by its sides, not by the front bezel.
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 Removing the Remaining Packing Materials 0 Now that you have removed the library from its shipping carton, remove the remaining packing materials from the library: 1 Remove the antistatic sheet from the library as follows: a Cut the tape strips securing the sheet. b Fold the sheet down. c With the help of a second person, lift the library up off of the antistatic sheet.
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 5 Push the button next to the right magazine access door (see figure 3). The right magazine access door opens. Figure 3 Opening the Right Magazine Access Door Right magazine access door Button 6 Grasping the handle at the front of the magazine, slide it forward and out of the library (see figure 4). Figure 4 Removing the Magazine Magazine 7 Push the button next to the left magazine access door (see figure 5).
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 Figure 5 Opening the Left Magazine Access Door Button Left magazine access door 8 Using a slender object such as a pen, press and hold the magazine release button (see figure 6). Figure 6 Magazine Release Button, Left Side Only 9 Grasping the handle at the front of the left magazine, slide it forward and out of the library.
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 Figure 7 Removing the Foam Pads that Support the X-Y Tray Left foam pad Right foam pad 11 Move the robotic hand to the back of the library by reaching through the right magazine access door. Grip the steel flange on the “Y” slide (see figure 8) and push the robotic hand to the back of the library. Caution: 8 Avoid touching the printed circuit board and its ribbon cable connector.
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 Figure 8 Pushing the Robotic Hand toward the Back of the Library Steel flange 12 Being careful to touch only the foam pad on the robotic hand, gently rotate the robotic hand 90° counterclockwise until it reaches its limit. 13 Gripping the lower edge of the foam pad, pull to the right and remove it off the robotic hand and out from the library (see figure 9).
Quantum ATL M1500 Unpacking Instructions Document 6421002-06 A01 July 2003 14 Replace the left and right magazines. 15 Close the magazine access doors. The library is now unpacked and ready to be installed in its final location. Refer to the Quantum ATL M-Series Installation Guide (6423001) for installation instructions. Checking the Contents 0 Compare the contents of the shipping carton and the accessories kit with the items listed on the label on the outside of the shipping carton.
