User's Guide

Troubleshooting and Diagnostics 35
4. Within 60 seconds, insert a scratch data cartridge that is not write-protected (or the drive will exit Maintenance Mode).
Caution
Data on the cartridge will be overwritten. Insert only a scratch data cartridge for
these tests.
After you insert the cartridge, the front panel indicators will display the following:
Indicator State, Character, or Message
Status LED
Amber, solid
Single-character display
5
LCD
Copy Dump to Tape
Tape Loading ====
while the drive writes the dump data to the scratch data tape (at BOT).
When Copy Dump to Tape finishes copying the data to the scratch cartridge, the front panel indicators display the
following:
Indicator State, Character, or Message
Status LED
Amber, solid
Single-character display
5
LCD
Copy Dump to Tape
Passed!
Followed by:
Cartridge Unloading
In Progress
The drive will then unload the cartridge and exit Maintenance Mode. The front panel indicators display the following:
Indicator State, Character, or Message
Status LED
Green, solid
Single-character display Off
LCD
Ultrium Tape Drive
Drive Empty
If an error occurs while the drive is running the Copy Dump to Tape function, the front panel indicators display the
following:
Indicator State, Character, or Message
Status LED
Off
Single-character display
7, flashing
LCD
Error!
Media Problem
To resolve the error, refer to Table 4-2 Error Codes elsewhere in this chapter. To clear the error, cycle (remove, then reapply)
power to the LTO standalone.